CAPE Forum

Ansys => Fluent => Topic started by: pitney1 on February 11, 2012, 01:11:52 PM

Title: Error: Divergence detected in AMG solver: x-momentum
Post by: pitney1 on February 11, 2012, 01:11:52 PM
Why am I getting divergence on the first iteration for an axisymmetric problem?

I am running a 2d axisymmetric simulation but it diverges on the first iteration with the following message:

Divergence detected in AMG solver: x-momentum -> Increasing relaxation sweeps!

Error: Divergence detected in AMG solver: x-momentum
Error Object: #f

Title: Re: Error: Divergence detected in AMG solver: x-momentum
Post by: william on February 11, 2012, 01:13:47 PM
One reason could be that the geometry is not correct. Do a Mesh->Check to make sure you don't get

Checking for nodes that lie below the x-axis.
WARNING: Invalid axisymmetric mesh: 6 nodes lie below the x-axis.

and
WARNING: Mesh check failed.


For axisymmetric, the axial direction should be x and radial is positive y. Even if the y starts with -1e-32, it will fail.

To fix this:
Use Mesh->Translate and move the geometry so ymin is +ve.
Title: Re: Error: Divergence detected in AMG solver: x-momentum
Post by: zeybi1604 on March 13, 2012, 06:03:55 PM
Hello. i am doing a multiphase simulation in a packed bed using the mixture model. the volume fraction used was 0.5316.i keep getting the error message "divergence detected in AMG solver: x-momentum" for all the different solvers used and i even changed the under relaxation factors. i really have no idea how to proceed with this simulation!plzz help!thank u.
Title: Re: Error: Divergence detected in AMG solver: x-momentum
Post by: william on March 13, 2012, 08:06:20 PM
Please try running the simulation in transient mode and set the time stepping method to adaptive.