CAPE Forum

Ansys => Fluent => Topic started by: moloy_kb on July 12, 2012, 11:04:05 AM

Title: Porous media in Fluent
Post by: moloy_kb on July 12, 2012, 11:04:05 AM
Dear all..
Please find the attached document, where I clearly mentioned about the problem that I am facing regarding the formulation of the problem.
Any help is highly appreciated.
Title: Re: Porous media in Fluent
Post by: sfotovati on July 13, 2012, 09:06:00 PM
Simply draw the geometry in Gambit or Cubit or any other meshing software. the only important thing is to specify different zones for wire (solid), polymer (Fluid1), media(fluid 2)... The in Fluent, mark polymer (zone for fluid 1) as porous. specify the correct porousity and you are done.

good luck,

Sean