Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - iitgbim

Pages: [1]
1
Fluent / Re: error in udf interpretation
« on: October 29, 2012, 10:58:20 AM »
Please help me in degassing boundary condition udf as attached,

2
Fluent / Re: error in udf interpretation
« on: October 26, 2012, 12:25:00 PM »
When I tried to compile, I got following error:
degas.c
..\..\src\degas.c(174) : error C2061: syntax error : identifier 'degas_treat_symm_thrd_p'
..\..\src\degas.c(174) : error C2059: syntax error : ';'
..\..\src\degas.c(174) : error C2059: syntax error : 'type'
..\..\src\degas.c(470) : error C2065: 'boolean' : undeclared identifier
..\..\src\degas.c(470) : error C2146: syntax error : missing ';' before identifier 'my_sg_mphase'
..\..\src\degas.c(470) : error C2065: 'my_sg_mphase' : undeclared identifier
..\..\src\degas.c(472) : error C2143: syntax error : missing ';' before 'type'
..\..\src\degas.c(474) : error C2065: 'seco_phse_indx' : undeclared identifier






Please suggest me what to do? Can it run after compiling?

3
Fluent / error in udf interpretation
« on: October 25, 2012, 11:44:52 AM »
Hi

I am unable to interpret the attached udf. It says parse error in flowf.h. Please help me.

4
Fluent / Re: gas escape from stirred tank
« on: October 11, 2012, 04:06:49 AM »
Air is sparged through inlet boundary, which is below the impeller. Please suggest me how to set mass outflow at the top.

5
Fluent / gas escape from stirred tank
« on: October 10, 2012, 11:28:59 AM »
Hi

I am using sparger as velocity inlet of air. Now I ma facing problem in gas holdup diagram. It shows that the whole container is filled with gas. Please suggest me how to set gas outlet condition in fluent (I have tried with top level with pressure outlet). Please suggest me.

6
Fluent / Re: UDF for population balance method
« on: August 25, 2012, 04:40:10 PM »
Will you please tell me which parameter I should have for my problem (Gas-liquid Stirred tank)?

7
Fluent / UDF for population balance method
« on: August 25, 2012, 10:06:32 AM »
I am in need for udf for PBM applicable to gas-liquid stirred tank. Please share if you have any

Pages: [1]