Author Topic: Convergence of FLUENT calculations involving combustion and radiation  (Read 3545 times)

Offline infocfd

  • Newbie
  • *
  • Posts: 45
  • Reputation: +0/-0
  • Searching for solution
    • View Profile
Advertisement
Hi,

How can I improve the convergence of FLUENT calculations involving combustion and radiation?

Thanks.

Offline william

  • Full Member
  • ***
  • Posts: 159
  • Reputation: +15/-0
  • Know it, share it.
    • View Profile
Re: Convergence of FLUENT calculations involving combustion and radiation
« Reply #1 on: February 13, 2012, 08:52:54 PM »
Steady state calculations are independent of the initial condition specified. However, the use of combustion and/or radiation models introduces significant nonlinearities in the transport equations and a poor initial condition may even cause divergence of the solution. To enhance solver robustness and stability and decrease overall solution turnaround times, here is a suggested solution procedure:

To start with, run the calculation with only the flow equations turned on (cold flow solution) for about 100 iterations or so until the solution shows reasonable convergence. In this step, use the "Solution Controls" GUI panel (Solve->Controls->Solution...) to activate or deactivate equations.

Next, activate the calculation of the energy equation as well as the species equations (or the PDF equation if you are using the PDF combustion model).