Author Topic: How can I set a wall velocity at a fluid-solid interface in CFX?  (Read 7253 times)

Offline pitney1

  • Jr. Member
  • **
  • Posts: 65
  • Reputation: +0/-0
  • Searching for solution
    • View Profile
Advertisement
I wish to set a wall velocity at a fluid-solid interface. How can I do this?

Offline william

  • Full Member
  • ***
  • Posts: 159
  • Reputation: +15/-0
  • Know it, share it.
    • View Profile
Create the fluid and solid domains in the usual way. If you are solving a rotating problem, your fluid domain should be setup as a rotating domain while the solid domain must be stationary.
Do not create any wall boundary conditions on these surfaces. Create fluid-solid domain interfaces in the usual way. Once you have create the domain interface, you will see that CFX-Pre has automatically created some boundary conditions for the fluid and the solid side. You can then edit the fluid side boundary condition and set a wall velocity, or a counter rotating wall, or leave the walls as stationary as required. A stationary wall is always stationary with respect the the local domain.