Author Topic: How to mark two different region in complex geometry  (Read 13733 times)

Offline lucaaa

  • Newbie
  • *
  • Posts: 3
  • Reputation: +0/-0
  • Searching for solution
    • View Profile
How to mark two different region in complex geometry
« on: June 21, 2012, 11:22:06 AM »
Advertisement
Hi,

First of all I would excuse me for my English.
I try to simulate a fluidized bed reactor 3D and I have a complex geometry. Before I proceed to calculate my solution (unsteady) I must mark region of my geometry and so how to do it? -I've complex geometry and i don't know if is possible to mark two different regions in same time. I hope someone help me.

Luca

Offline william

  • Full Member
  • ***
  • Posts: 159
  • Reputation: +15/-0
  • Know it, share it.
    • View Profile
Re: How to mark two different region in complex geometry
« Reply #1 on: June 21, 2012, 12:11:07 PM »
Can you explain what you mean by marking of the geometry?
If you mean different volumes, then you can make the geometry in such a way that you don't unite all the volumes. You just have to stitch the joint faces of different volumes.

Offline lucaaa

  • Newbie
  • *
  • Posts: 3
  • Reputation: +0/-0
  • Searching for solution
    • View Profile
Re: How to mark two different region in complex geometry
« Reply #2 on: June 21, 2012, 01:56:50 PM »

The black area is the area that i would mark. How can i do it?? :(
In a simple geometry I follow this steps:
Adapt -> Region and then i set the min and max values. In my case I have a complex geometry. If I proceed with the similar method that I use for the simple geometry, I obtain only upper black region and empty in the bottom.

Offline william

  • Full Member
  • ***
  • Posts: 159
  • Reputation: +15/-0
  • Know it, share it.
    • View Profile
Re: How to mark two different region in complex geometry
« Reply #3 on: June 21, 2012, 05:57:02 PM »
What is in the black region?

Offline lucaaa

  • Newbie
  • *
  • Posts: 3
  • Reputation: +0/-0
  • Searching for solution
    • View Profile
Re: How to mark two different region in complex geometry
« Reply #4 on: June 21, 2012, 06:04:01 PM »
There is solid phase