Author Topic: Porous media in Fluent  (Read 9006 times)

Offline moloy_kb

  • Newbie
  • *
  • Posts: 19
  • Reputation: +0/-0
  • Searching for solution
    • View Profile
Porous media in Fluent
« on: July 12, 2012, 11:04:05 AM »
Advertisement
Dear all..
Please find the attached document, where I clearly mentioned about the problem that I am facing regarding the formulation of the problem.
Any help is highly appreciated.

Offline sfotovati

  • Newbie
  • *
  • Posts: 8
  • Reputation: +0/-0
  • Searching for solution
    • View Profile
Re: Porous media in Fluent
« Reply #1 on: July 13, 2012, 09:06:00 PM »
Simply draw the geometry in Gambit or Cubit or any other meshing software. the only important thing is to specify different zones for wire (solid), polymer (Fluid1), media(fluid 2)... The in Fluent, mark polymer (zone for fluid 1) as porous. specify the correct porousity and you are done.

good luck,

Sean
Sean