« previous next »
Pages: [1]

Author Topic: gas escape from stirred tank  (Read 11377 times)

Offline iitgbim

  • Newbie
  • *
  • Posts: 7
  • Reputation: +0/-0
  • Searching for solution
    • View Profile
gas escape from stirred tank
« on: October 10, 2012, 11:28:59 AM »
Advertisement
Hi

I am using sparger as velocity inlet of air. Now I ma facing problem in gas holdup diagram. It shows that the whole container is filled with gas. Please suggest me how to set gas outlet condition in fluent (I have tried with top level with pressure outlet). Please suggest me.
Logged

Offline william

  • Full Member
  • ***
  • Posts: 159
  • Reputation: +15/-0
  • Know it, share it.
    • View Profile
Re: gas escape from stirred tank
« Reply #1 on: October 10, 2012, 07:35:53 PM »
What is your inlet boundary condition?
Make sure that the pressure at the outlet face is smaller than upstream pressure.

You can set mass outflow as the outlet boundary condition if you don't have backflow at the outlet.
Logged

Offline iitgbim

  • Newbie
  • *
  • Posts: 7
  • Reputation: +0/-0
  • Searching for solution
    • View Profile
Re: gas escape from stirred tank
« Reply #2 on: October 11, 2012, 04:06:49 AM »
Air is sparged through inlet boundary, which is below the impeller. Please suggest me how to set mass outflow at the top.
Logged

Offline william

  • Full Member
  • ***
  • Posts: 159
  • Reputation: +15/-0
  • Know it, share it.
    • View Profile
Re: gas escape from stirred tank
« Reply #3 on: October 11, 2012, 09:33:47 AM »
Logged
Pages: [1]
« previous next »
 

+ Quick Reply