19
« on: May 12, 2012, 02:48:33 PM »
I want to specify velocity inlet to interior face zone in the mesh. I have a cylinder completely inside the a box. The inside of the cylinder is meshed and have cell zone fluid-1, and outside of the cylinder is meshed with cell zone fluid-2. The inlet and outlet of the pipe is an interior type and are named interior-5, and interior-6, respectively. There is node-connectivity between fluid-1 and fluid-2 at all the boundary zones of the pipe.
I know the velocity of the fluid entering. Also, the fluid of the pipe does not mix with the fluid outside at the outlet of the pipe. How to specify velocity inlet to the pipe and make the fluid inside the pipe exit the domain at the outlet?