Post reply

Note: this post will not display until it's been approved by a moderator.

Message icon:

Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:

shortcuts: hit alt+s to submit/post or alt+p to preview

Topic Summary

Posted by: william
« on: November 13, 2016, 02:44:47 PM »

Walls between Fluid - Solid zones are created automatically when imported into FLUENT even if not set in the geometry software, but interfaces between two solids are treated as interior zones by default.
The boundary between two solid zones is treated as interior surface by default. In the boundary conditions panel, boundary type can be changed from interior type to wall.