Post reply

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: william
« on: May 11, 2012, 10:30:51 PM »

To be able to select different wall boundary conditions for different fluids, you need to:
1) set 'Fluid Dependent' option for 'Turbulence' in the Fluid models
2) on the Boundary Condition settings tab, select 'Fluid Dependent' option for 'Wall Influence On Flow'. An extra tab 'Fluid Values' will appear. There you can set up different boundary conditions for different fluids.
Posted by: pitney1
« on: May 11, 2012, 10:30:24 PM »

How should you set up different wall boundary conditions for different fluids in a CFX 10.0 multiphase calculation?