Post reply

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: pico
« on: January 25, 2012, 04:02:04 PM »

goCFD is recommended when you have very small of the order of the size of the mesh in CFD. What it does it it takes information from CFD in each cell and solves the defined equations describing the process like crystallization, heat and mass transfer, reactions etc.. in gProms and sends it to the CFD again.

In the multi zonal modelling, you specify the zones yourself in gproms. The zones are of the order of 10 to 100 (comparably many times coarser than the CFD mesh). Each zone takes the information from CFD like fluid flow hydrodynamics and solves the model equations describing the process like heat transfer, mass transfer etc. in gPROMS.
Posted by: deord
« on: January 23, 2012, 09:14:50 PM »

Sorry for my lack of knowledge...
I am a beginner in zonal modelling. I am told that I can use gPROMS for zonal modelling. It has two interfaces (i assume???) one is goCFD and other is hybrid multizonal modelling..
I dont know which one to use and how to use it and extract data from Fluent...
Can any one suggest me some general idea about both and how to use this with Fluent?

Many thanks in advance.