Post reply

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: william
« on: October 11, 2012, 09:33:47 AM »

Posted by: iitgbim
« on: October 11, 2012, 04:06:49 AM »

Air is sparged through inlet boundary, which is below the impeller. Please suggest me how to set mass outflow at the top.
Posted by: william
« on: October 10, 2012, 07:35:53 PM »

What is your inlet boundary condition?
Make sure that the pressure at the outlet face is smaller than upstream pressure.

You can set mass outflow as the outlet boundary condition if you don't have backflow at the outlet.
Posted by: iitgbim
« on: October 10, 2012, 11:28:59 AM »

Hi

I am using sparger as velocity inlet of air. Now I ma facing problem in gas holdup diagram. It shows that the whole container is filled with gas. Please suggest me how to set gas outlet condition in fluent (I have tried with top level with pressure outlet). Please suggest me.