Post reply

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: sfotovati
« on: July 13, 2012, 09:06:00 PM »

Simply draw the geometry in Gambit or Cubit or any other meshing software. the only important thing is to specify different zones for wire (solid), polymer (Fluid1), media(fluid 2)... The in Fluent, mark polymer (zone for fluid 1) as porous. specify the correct porousity and you are done.

good luck,

Sean
Posted by: moloy_kb
« on: July 12, 2012, 11:04:05 AM »

Dear all..
Please find the attached document, where I clearly mentioned about the problem that I am facing regarding the formulation of the problem.
Any help is highly appreciated.